Contactors

Yes, it is.

Vacuum contactors use encapsulated contacts with vacuum instead of air as the medium to eliminate arcing. Vacuum contactors are only...

Yes, we at INKOM have our own assembly department that does customized final assembly, etc.

Yes, all system solutions are in accordance with TSFS 2020:88.

All side channel fans with 3-phase motors can be speed controlled with frequency converters.

Electric side channel fans are standard equipped with IE2 motors in accordance with IEC 60034-30.

Watch this video explaining it  

This question must be broken down into several parameters. The amount of current that can flow through the contactor continuously...

In each contactor there is a coil that operates switching and breaking, the voltage to control the coil can vary...

The contactor can either be controlled to one mode or both modes, for switching on or off. For example, a...

High short-circuit currents and an unregulated closing with load is the most common reason for the contactor to weld. This...

NO = Normally Open, NC = Normally Closed. This describes the state of a contactor when the voltage in the...

When an electromechanical component such as a contactor is exposed to a situation that causes it to fail, it does...

It will form an arc with a lot of energy. The best way to extinguish it is with permanent magnets...

For each contactor, there is a short-circuit current and a time that it must withstand. If this is higher and...

A contactor is defined according to IEV ref 441-14-33 as a mechanical switching device with only one rest position, operated...

An economizer is an electronic circuit that regulates (PWM) the turn-on power and hold power of the coil. An economizer...

Traditionally, contactors have worked with coils to force the arc to the arc chamber for extinguishing. During arc formation, the...

When breaking both + & and – in case of anomalies in the system.

Pre-charge, in the context of a DC (direct current) system, refers to a process of gradually charging the capacitance or...

SR and SRM linen stoppers are approved according to IEC 947-5-5, DIN EN 60947-5-5 and ISO 13850.

Historically, contactors have been used to directly switch on and off electrical loads, such as electric motors, and even today...

A contactor is a vital safety component in any electrical system, Schaltbau stands for new patented technology. By far the...