Transducers & sensors
Interfaces: CANopen Safety, Relay
Single or Multiturn: Multiturn
construction: 58 mm, 64 mm, 65 mm, 66 mm, 79 mm
Special function: SIL2 / PLd
Flange and axle: Clamped flange, axle 10 mm with spring wrench, Clamped flange, axle 10 mm with
flattened area, Clamped flange, shaft 12 mm for measuring equipment ZRS, Clamped flange,
shaft 12 mm with spring key, Clamped flange, shaft 12 mm, with flattened area,
Synchronizing flange, shaft 12 mm with spring key.
Number of switching outputs: 2 switching outputs SIL2. With NOCN79: Up to 4 switching outputs SIL2
Housing material: Aluminum, Stainless Steel 1.4305, Stainless Steel 1.4404
Resolution: 4096 = 12 bits. 8192 also possible. With NOCN79: 16.384 (14 bits) and
32,768 (15-bit)
Code type: Binary, Ring function (only with NOCN without breaking contacts)
Measuring range: 16 turns, 256 turns, 4096 turns
Profile: CANopen safety profile and SIL2 switching outputs, if available, CANopen standard profile and SIL2 switching outputs.
Electric connection: 1 connection, 2 connections, 3 connections, cable, 1 m, radial (other lengths)
on request), Device connector M12, radial, Via cable 1 m, axial (with NOCN79 only on request), Via device connectorM12, axial (with NOCN79 only on request).
Galvanic separation: -UB = CAN_GND = shield / enclosure, -UB = CAN_GND ND shield / enclosure,
-UB ǂ CAN_GND ǂ screen / housing (recommended)
Electrical / mechanical variant: As standard but with shaft sealing ring, Standard
Transducers & sensors
Transducers & sensors
Transducers & sensors
Transducers & sensors
Transducers & sensors
Transducers & sensors
Transducers & sensors
Transducers & sensors
Switching cam encoder NOCN / S3 SIL2/PLd A game-free electronic switching cam encoder (abbreviated to: NOCN) with two (at version 79 four) galvanically separated switching outputs (cams), which can be set by the customer and which are activated or
is deactivated depending on the relevant position on the drive shaft. An absolute multiturn encoder with CANopen interface, adjustable parameters and
an electronic switching chamber module is realized in the compact housing. A separate controller monitors the operation of the camera. The encoder’s CANopen position signal and the switching outputs can be parameterized separately. Parameterization (comb limits, resolution, measurement range, etc.) must be verified to the NOCN via a checksum. This checksum can be calculated using a TWK program or the standard algorithm recommended by CiA. After verification, the unit can be put into operation. The preset and resolution of the position signal also affects the chambers that refer to the position signal. Parameterization is performed via relevant CANopen objects in accordance with the encoder profile according to CiA, DS 406, revision 4.01.